APB Dynasonic ProDesk 432 32 mic/line og 4 stereo line
[PRODESK-432]

APB Dynasonic ProDesk 432 32 mic/line og 4 stereo line

Teknisk specifikationer
Frequency Response: 
+0/-0.5dB 20Hz - 20kHz Ref 1kHz (Any input to any output)
Noise:
Mic EIN Less than -128dBu (150 ohm source, 60dB gain)
Bus Noise:
‹-85dBu 20Hz - 20kHz 32 Channels routed with faders down, Master fader at unity.
‹-95dBu with Master fader down
THD: 
‹0.02% Mic Input to Main Outputs (Left/Right/Center/Mono )
Crosstalk at 1kHz:
‹-90dB Channel to Channel
‹-90dB Channel to Mix
‹-90dB Mix to Mix
‹-90dB Fader Attenuation
Phase Shift:
 ‹ +/- 15 degrees @ 20Hz - 20kHz
Maximum Input Levels:
+31dBu (with Pad) Mic Pre-amp Input
+21dBu All Other Inputs
Nominal Output Levels:
+4dBu
Maximum Output Levels:
Capable of driving 600 ohms or greater
Balanced Mains (Left/Right/Center/Mono), Aux Outputs 1 through 6, Matrix Outputs 1 through 4
+28dBu into 2k ohm or higher - All Other Outputs +21dBu Impedance Balanced
Inputs/Outputs:
Mic Inputs : 4k ohm balanced
Max Voltage Gain: Mic In to Main Out: 95dB
Line Inputs: ›10k ohm balanced
Mix/Aux Outputs : 100 ohms Balanced
Monitor/Direct Outputs: 100 ohm Ground Compensated
Headphone Output:  To drive 8 ohms or greater - 1/4" and 1/8" connectors
Insert Sends: 100 ohm Unbalanced
Insert Returns: 10k ohms Unbalanced
RCA Input: 10k ohms Unbalanced
USB Digital Output: Stereo 16 Bit  
Master Metering:
Four - 16-segment LED meters - Modes:
 - Peak, Average, or Simultaneous Peak/Average
 - Master Outputs (4) - Left / Right / Center / Mono
Four - 8 Segment LED meters - Group Outputs (4)
Solo Metering and Solo ON LED - Shares Center /Mono master meters
Mono Input Channel Metering:
6-Segment LED with multi-point clip warning
Mono Input Channel EQ:
Low Cut Filter = 12dB/oct @ 20Hz to 400 Hz
Low Frequency EQ = +/- 15dB @ 80Hz Shelving
Low Mid EQ = +/- 15dB @ 80Hz to 2kHz @ 1 octave BW
High Mid EQ = +/- 15dB @ 400Hz to 8kHz @ 1 octave BW
High Frequency EQ = +/- 15dB @12kHz Shelving
Channel Access:
Insert Point: Post Low-Cut Filter / Pre-EQ
Direct Out: Post Pre-amp / Pre Low-Cut filter (default)

Beskrivelse
Available in modular blocks of 16, 24, 32, 40, and 48 Mic/Line Input Channels.
All versions include 4 Stereo Line input channels with Split Track capabilities.
Input channels include high quality 100mm Faders, Internally illuminated Mute and PFL switches, 6 segment channel metering, 48 Volt Phantom Power switch with LED, mic/line, Pad and Polarity Reverse switches.
6 Auxiliary sends are switchable pre/post fader in pairs and pre/post EQ as a pre fader group and include 1 pair of auxiliary sends that are switchable between mono and stereo operation.
4 band EQ with sweepable mid-frequencies with a 1 octave bandwidth and EQ On switch with LED, Variable High pass filters with a 20Hz-400Hz with On switch with LED.
Outputs include 6 Auxiliary outputs, 4 analog subgroups, 4 matrix outputs, Left/Right, Center, and Mono (subwoofer). All include XLR Balanced output connectors, TRS pre fader insert points, and TRS Balanced bus inputs.
Digital USB Stereo Input and Record Output.
Four (4) channel mute group system with individual channel mute group active indicators.
Remote muting of all primary outputs using a single opto-isolated Phoenix connector and may be configured to respond to an external open or closed (relay) circuit.
Internally illuminated PFL, AFL, and Mute indicators on all input and primary output channels.
Spectra derived construction includes the use of mother and daughter board construction for easy service and uncompromised performance.
Low phase shift and extended bandwidth design.
Plug in Power Supply (same unit as used on Spectra Consoles) for ultra reliability. An optional redundant power supply can be added to all but the 16 mono input chassis systems. A console cover is supplied with all models of ProDesk-4.
Depth: 23.5" Max Height: 8.9" (without optional lamps).
Width: 16 Mono input 30.8", 24 Mono input 38.8", 32 Mono input 46.9", 40 Mono input 55", 48 Mono input 63.1"krivelse